Toilet runs off and on

Posted on by

Troubleshooting a Toilet That Runs When Not Flushed

toilet runs off and on

How to Fix a Running Toilet - 3 Most Common Problems

and    funny things to say when picking up the phone

Step 1 — If you have shut off the water supply line, then turn on water and look inside the tank. Determine if the water level is rising so high it is draining into the overflow pipe. If the answer is yes then follow the steps for cleaning the fill valve. It is possible for dirt and debris to lodge itself inside the valve. This can happen any time the water is on and may happen after a new installation, a few days later or even months and years after installation.

Take the guess work out of repairing your broken water heater. Our trained technicians can diagnose and fix any issue. We are there for you in the case of a plumbing emergency day or night seven days a week. No matter how big or small your commercial or residential plumbing project is — TitanZ Plumbing has got you covered. Sometimes does your toilet start running for a few seconds at a time, like its topping off your tank?

A toilet that runs continuously or turns on and off even when not in use has a leak somewhere. Most toilets are gravity-flow devices, with a tank that holds water and a bowl that is emptied when flushed and refilled from the tank. A float or fill valve controls the level of water in the tank and shuts off the supply when the tank is full. If this device fails, the water won't shut off or will start running again when the water level drops from a leak. Finding the leak is the key to the repair. Put a few drops of food coloring into the reservoir tank and wait without flushing until the water turns on again.



Subscribe to RSS

Fix a Toilet that Randomly Refills Water Tank

Does Your Toilet Randomly Start Running?

A running toilet can waste hundreds of gallons of water per day while racking up your water bill. The best way to fix a running toilet is to start by inspecting the toilet flapper for issues. Toilet flapper issues are one of the most common causes of a running toilet. If the toilet flapper seems fine, try adjusting the water level of your toilet. One way to fix a running toilet is by adjusting the flapper, which is a rubber seal that stops the water in the tank from draining into the toilet bowl. Start by turning off the water and flushing the toilet to drain the tank. Then, open the tank lid to inspect the handle, chain, and flapper.

By using our site, you acknowledge that you have read and understand our Cookie Policy , Privacy Policy , and our Terms of Service. It only takes a minute to sign up. Sometimes my toilet starts running for a few seconds at a time, like it's just finishing filling up the tank. Usually this happens when the bathtub is being drained, or when I turn on the facets in the sink, but I think it also happens sometimes when no water is being used anywhere else. As far as I can tell the flapper in the tank is working fine, and I don't see any leaks anywhere. The typical toilet tank will have a flapper which seals the water in the tank. When you flush the toilet, the flapper is lifted and water is allowed to move from the tank into the bowl.

.

Repair when Flushing

.

.

.

.

.

5 thoughts on “Toilet runs off and on

  1. Overview. Toilets haven't changed much in the last 80 years. After a flush, water still fills a tank, lifting a float that shuts off the water when it reaches a certain.

Leave a Reply